How to add the Finder to Cura: Go to: https://github.com/eskeyaar/Flashforge-Finder- Add 'definitions,' 'extruders,' and 'meshes' to installed Cura...
How to stop the sensor from dropping:
"One note about this setup: since Cura 4.2, you may see a weird behavior about the level sensor dropping out before print starts. Search for the setting 'Build Volume Temperature' and set it to zero in order to avoid that." Source: https://www.reddit.com/r/FlashForge/comments/cych1o/flashforge_finder_profile_for_cura_4/ Comments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
November 2020
Categories |